Spool and repairing threads (3D Printed)

The blue thread has been glued on to repair the bad thread that was there

Assembled

Bad thread, the slicer settings not set right

Close up

This is what the thread should look like, slicer settings were modified for the improvement and a similar solid model that had a better design for printing was used

The repair begins, removing the thread

Installing new thread with hot glue

Installed and glued

All done. It disassembles so new filament can be installed.

Find on Thingiverse, this is the best one i found so you don't have to repair the thread like i did.